JENSEN™ Highway Plows
- Customer pickup,
- Courier
- In detail
- BrandJensen
3/16" thick and approximately 41" high with 8" cutting edge attached. Smooth formed with integral extension similar to moldboard contour. The "mailbox" cut-out on the top of moldboard (shown) is an option.
½" thick by 12" wide, 4 cord minimum rubber belting shield. Rubber shield is to be bolted to the moldboard in approximately a 45 ° position, with reinforcement bar across the front for strength. The bars are strong enough not to bend in normal operation of the plow.
8 ea. one-piece ribs are 2" - 3½" wide and 1/2" thick. The ribs are one-piece with no weld joints, and run from top to bottom of moldboard. Where the rib is fastened at the top, the bottom of the rib is cut to allow water to drain. The ribs have continuous welds.
Angle attachment of moldboard at the bottom is accomplished using a "Z" design. The angle is 4" x 2" x 4" material. Both flange edges of angle are welded continuously to the back side of moldboard with a 2"x4" flat bar under the angle on moldboard with continuous welds. Gussets are welded to bottom side of angle every 12" -18". The angle is enclosed at each end.